Install the Servo Headers

Install 4 3x4 pin male headers into the marked positions along the edge of the board.

Solder all pins

There are a lot of them!

Add Headers for Control

A strip of male header is included. Where you want to install headers and on what side depends a little on use:

For breadboard use, install headers on the bottom of the board.
For use with jumper wires, install the headers on top of the board.
For use with our 6-pin cable, install the headers on top of the board.

If you are chaining multiple driver boards, you will want headers on both ends.

Install Power Terminals

If you are chaining multiple driver boards, you only need a power terminal on the first one.

This guide was first published on Oct 16, 2012. It was last updated on Oct 16, 2012.

This page (Assembly) was last updated on Oct 16, 2012.

Text editor powered by tinymce.

Search